STACK TOLERANCE FOR DESIGN EVALUATION
A new strategy to produce high quality cost saving design Case studies and hands-on exercises using your company’s drawing
Curriculum
- 7 Sections
- 36 Lessons
- 21 Hours
Expand all sectionsCollapse all sections
- Introduction4
- Tolerance Stack Analysis3
- Types of Tolerance Stack4
- Overcoming Tolerance Stack9
- 5.1Direct dimensioning
- 5.2Tolerance Accumulation Between Surfaces
- 5.3Positional Tolerance
- 5.4Bidirectional Positional Tolerancing
- 5.5Single Axis of Two Coaxial features
- 5.6Single Axis of Two Datum features
- 5.7Position Tolerance Extended Principle
- 5.8Comparable Positional and Profile Controls Tolerance Stack with MMC Principle
- 5.9Composite Positional and Profile Controls Tolerance Stack with MMC Principle
- Design Tolerance Analysis3
- Tolerance Stack-up calculation and Analysis with GD&T5
- Tolerance Stack-up Exercises8
- 8.1MMC Position Tolerance of Holes Permissible Distance to Edge of External Feature
- 8.2MMC and LMC position Tolerance on holes permissible distance to a Wall
- 8.3LMC for Minimum Wall Thickness
- 8.4Worst Case Edge Gap of Holes to Datum Features
- 8.5Gap Calculation with Composite Position and Profile Tolerance
- 8.6LMC to Protect a Minimum Distance on Part
- 8.7Gap Calculation of Holes and Guide Pins with Material Condition
- 8.8Pattern Located by Composite Profile Tolerance Stack
Gap Calculation of Holes and Guide Pins with Material Condition
Prev